Not suitable for steel wire and hard drawn copper conductors
Precision ground, hardened blades
Clean and smooth cut without crushing and deformation
By dividing the cutting actions into initial cut (insulating sheath in the front cutting area) and final cut (conductor in the back cutting area), cables up to Ø 20 mm can be cut in one-hand operation
Less effort required due to favourable lever ratio and optimised cutting-edge geometry
Guard prevents operators’ fingers being pinched
Adjustable bolted joint, self-retaining screw
High-grade special tool steel, forged, oil-hardened
The twin cutting edge allows a comfortable handle position in all cutting situations within the specified cutting capacity.
Initial cut: using the front cutting edge to cut the insulating sheath on larger cable diameters leaves an ergonomic handle opening width.
Final cut: after cutting the sheath in the front profile the conductors in the rear part are cut. Initial cut in the front profile, final cut in the rear profile - to keep it as easy as possible.
