คีมตัดปากเฉียง 73 72 180 KNIPEX TwinForce® High Performance Diagonal Cutters KNIPEX

(3.125 จาก 12 โหวต)
2,500.00 บาท
2,175.00 บาท
รายละเอียด

  • The superior High-Leverage Diagonal Cutter with patented double joint
  • Ideal transmission of force due to double-hinged design
  • Reliably cuts all types of wire, including steel tape
  • For rough or very fine cutting
  • Low cutting impact: gentle on hands. The tension on muscles and tendons is relieved
  • For comfortable cutting, repetitive cutting or extremely hard cutting jobs
  • High degree of stability and zero-backlash due to precisely milled forged-in axles
  • Chrome vanadium heavy-duty steel, forged, oil-hardened
  •  

Extremely easy cutting with little strain:


cuts again 50 % easier than the tried and tested KNIPEX high leverage diagonal cutters
 

New for diagonal cutters:


The option to reapply the tool. The KNIPEX TwinForce® cuts even 4 mm thick wire without great effort when reapplied two or three times. Conventional high leverage diagonal cutters either cannot cut these diameters or only with very great effort.
7372180FH03D0.jpg
The high performance diagonal cutters with opening spring for easier reapplication and for heavy use
 
7372180FH01D0.jpg
The opening spring can be easily activated and deactivated by a press of the thumb
 
7372180H10D0.jpg
7371180H02D0.jpg
7372180H04D0.jpg
7372180H13D0.jpg
73_7_Animation1D0.jpg
Insert the wires as close to the hinge as possible. In case of cutters with very high transmission, the width of the gap between the cutting edges close to the fulcrum may be less than the thickness of the wire. Wires may slip forward when the cutting starts.
 
73_7_Animation2D0.jpg
First make a notch in the wire using the KNIPEX TwinForce® until the required hand force increases considerably. Now open the pliers and slide the wire backwards towards the joint. Hold the cutting edge in the notches you have made in step 1.
 
73_7_Animation3D0.jpg
Continue cutting in the same location along the wire. Now cutting is much more easier because the wire remains in place closer to the fulcrum.
 
73_7_Animation4D0.jpg
You can repeat this process if necessary.